Beltraco SP733 Powder-Coated Metal Restore Kit - Cleaning & Refreshing Powder-Coated Metal
Professional Cleaning and Refreshing of Powder-Coated Metal
Powder-coated metal surfaces are exposed to dirt, grease, dust and signs of use on a daily basis. With the Beltraco SP733 Powder-Coated Metal Restore Kit, these surfaces can be easily cleaned and refreshed.
The complete kit combines a powerful Powder-Coated Metal Cleaner with the conditioning Powder-Coated Metal Refresher. Together, they provide a clean, even and well-maintained finish with a subtle shine.
1. Beltraco Powder-Coated Metal Cleaner
The special cleaner has been developed for effectively cleaning powder-coated metal surfaces. Suitable applications include window frames and profiles, doors, gates, fences, conservatories and pergolas.
The cleaner helps remove:
Grease and general dirt
Adhesive residue from protective film
Rubber and marker stains
Fresh construction dirt
Stubborn dust and dirt
Thanks to its antistatic properties, dust and dirt are less likely to settle on the surface again. The cleaner does not leave a dull film and contains no chlorine.
Important: Do not use on uPVC/PVC.
2. Beltraco Powder-Coated Metal Refresher
After cleaning, the Powder-Coated Metal Refresher provides the finishing touch. This maintenance product is designed to refresh powder-coated metal surfaces and make signs of use less visible.
The refresher:
Refreshes the surface and enhances the appearance of the colour.
Provides an even and well-maintained appearance.
Gives a subtle shine.
Helps reduce the visibility of signs of use.
Slows down the build-up of dust and dirt.
Contains no wax or silicones.
Complete Maintenance Kit
The SP733 Powder-Coated Metal Restore Kit contains everything needed to clean and refresh powder-coated metal: two specialised maintenance products and two microfibre cloths.
Suitable for, among other applications:
Aluminium window frames and profiles
Exterior doors
Gates
Fences and railings
Conservatories
Pergolas
Other powder-coated metal surfaces
nstructions for Use
Step 1 – Cleaning
Apply the Beltraco Powder-Coated Metal Cleaner to a microfibre cloth and clean the contaminated surface. Then wipe the surface with a dry microfibre cloth.
Step 2 – Stubborn Dirt
Repeat the treatment if necessary for stubborn contamination.
Step 3 – Refreshing
Allow the surface to dry completely. Then apply the Beltraco Powder-Coated Metal Refresher to a clean microfibre cloth and distribute the product evenly over the cleaned surface.
Step 4 – Polishing
Allow the product to work for approximately 10 minutes, then polish with a clean, dry microfibre cloth.
Important Information
Always test the product first on an inconspicuous area.
When using on exterior surfaces:
Do not apply in direct sunlight.
Do not use on heated components.
Do not apply at temperatures below +5 °C.
Do not use on uPVC/PVC.
Kit Contents
1x Beltraco Powder-Coated Metal Cleaner – 250 ml
1x Beltraco Powder-Coated Metal Refresher – 250 ml
2x Grey microfibre cloths – 20 × 20 cm
Available: per set
